4/12/2023 0 Comments Dashware vs racerender![]() ![]() Once the RaceCapture device is found, select it to pair.Your phone/tablet will search for available devices. Under your phone/tablet's Android Settings, navigate to the Bluetooth section.We recommend connecting with Bluetooth when using Android devices. This is a good way to set up and test your RaceCapture system on the bench. Connect the RaceCapture device to your computer via the supplied USB cable this will also provide power to the unit. USB drivers will require installation instructions below. Windows XP, 7, 8: Not supported due to outdated video drivers, but may work depending on the video hardware used.Windows 10 and OSX: No USB drivers are needed for OSX or Windows 10.Not sure what tablet to use? See our list of recommended tabletsÄownload the Windows or OSX app from the downloads site.Note, this may degrade your GPS performance vs. Alternate Mounting: You can mount it on the dashboard in clear view of the sky, or on the rear parcel tray under the back window.Place the antenna with minimum 3 feet spacing from other transmitting antennas (car radios, cellular antennas, etc). Ideal: Mount the antenna on the roof of the vehicle, using the magnetic mount.You can attach the unit with hook and loop fastener, if that is convenient.Īttach the GPS antenna connector to RaceCapture and screw to 5-6 inch lbs - just beyond finger tight to prevent the connector from vibrating loose. Ideally, install the unit in a hidden location, shielded from heat and moisture. ![]() If installed in a non-standard orientation, you can go into Setup and re-map the accelerometer and gyro channels to match your changes. flat/upright, on-edge, upside down - etc. Note If you must install the unit in a different orientation, install with 90 degree orientation to the plane of the vehicle e.g. This is the factory orientation for the accelerometers and gyro. Place the RaceCapture system on a level surface in your car, with the RJ45 and USB connectors facing forward and logo up. You can resolve the issue by going through the firmware update process again. If you see this when the the unit powers up and you cannot connect with the RaceCapture app, it usually means a failed firmware upgrade. * Very fast green flash: Very rapid green flash indicates the unit is in bootloader mode, during firmware updates.Slow green flash : GPS searching for lock.Green - GPS Status (or firmware update status).Your RaceCapture system has a status LED that will indicate the current status of the system: Plug the other end of the cable into your car's OBDII port.Plug one end of the OBDII cable into the RaceCapture RJ45 port.Unpackage the RaceCapture system and included OBDII cable and GPS antenna. 4.6 Recovering from mis-configured WiFi or Bluetooth.4.5 Calibrating Sensors attached to AnalogX.4.4 Enabling the CAN preset and calibrating sensors.2.8.5 Comparing laps / runs between sessions. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |